Damp towels after a full hour, a squeal with every turn, or a drum that won't start at all. Our technicians fix both gas and electric models in Bellaire homes so laundry day finishes in one cycle again.

Six dryer troubles fill most of our Bellaire schedule. Every strip covers early warning signs, a sensible thing to do today and the parts we find guilty most often.
Why are my clothes still cold?!
What You'll Notice
The drum spins, minutes tick away, yet the load comes out cool, limp and every bit as soggy as when it went in.
Meanwhile…
While You Wait
Check that the breaker hasn't half-tripped on an electric model, or that the gas shutoff is fully open on a gas one, then try a timed dry setting.
The Usual Suspects
Two cycles for one pair of jeans!
What You'll Notice
Towels need two or even three runs, the outside of the cabinet feels unusually hot, and the clothes smell faintly scorched.
Meanwhile…
While You Wait
Pull out the lint screen, scrub it in the sink to strip off waxy softener residue, and dry smaller loads until it's checked.
The Usual Suspects
It sounds like a squeaky shopping cart!
What You'll Notice
A high squeal as the drum spins, a rhythmic thump, or a scraping noise that grows louder each week.
Meanwhile…
While You Wait
Empty the drum and check every pocket from the last few loads. Coins, keys and bra wires love to hide in the drum seams.
The Usual Suspects
I press start and... nothing.
What You'll Notice
The panel lights up, or stays dark, but the motor never kicks on when you hit start.
Meanwhile…
While You Wait
Close the door firmly, hold start for two full seconds and confirm that no lock icon is showing on the panel.
The Usual Suspects
It just stopped halfway through!
What You'll Notice
The dryer runs ten or fifteen minutes, goes quiet, then sometimes starts up again after it cools down.
Meanwhile…
While You Wait
Let the dryer cool completely, clean the lint screen and run a shorter cycle with a lighter load.
The Usual Suspects
The motor runs, but the drum is frozen!
What You'll Notice
The motor hums along, but the drum doesn't move, or it turns freely by hand with no resistance at all.
Meanwhile…
While You Wait
Unplug the dryer before reaching inside, then try rotating the drum with one hand. Spinning far too freely or barely budging both point to a broken belt or seized roller.
The Usual Suspects
Modern dryers show a short code whenever some part misbehaves. Below are several that Bellaire homeowners mention to us often, so you know whether to try a reset or call.
| Code | Brand | What It Means | Your Move |
|---|---|---|---|
| tE1 | ![]() |
Thermistor faultThe sensor that reads drum heat is open or shorted. | Call a tech |
| dE | ![]() |
Door openPress the door shut so the latch catches, then restart. | Try a reset |
| HS | ![]() |
Humidity sensor faultThe moisture sensor is giving bad readings. | Call a tech |
| HE | ![]() |
Heating errorThe dryer cannot reach its set heat level. | Call a tech |
| tS | ![]() |
Thermistor shortA temperature sensor circuit is shorted. | Call a tech |
| dE | ![]() |
Door switch errorReopen and close the door, then restart the cycle. | Try a reset |
| PF | ![]() |
Power failurePress start again to clear it after an outage. | Try a reset |
| F01 | ![]() |
Control board faultThe main control has stopped working properly. | Call a tech |
| F22 | ![]() |
Exhaust thermistor openThe sensor near the blower has lost contact. | Call a tech |
Got a code we didn't mention, or one that shows up again after restarting? Reach us at (587) 111-1111
Before
It took our dryer two and a half hours to finish one load of towels.
After
The tech found a worn heating element, replaced it on the spot, and towels are dry in one cycle again.
Joaquin T.Southside Place
Before
A loud squeal every time the drum turned, even with a light load.
After
New rollers and an idler pulley, and the noise is gone.
Wenonah C.Bellaire Oaks, Bellaire
Before
Dryer would hum for a moment and then go silent.
After
A bad door switch, swapped in under an hour.
Cosimo P.Loveland Terrace, Bellaire
Lint buildup and a few overlooked settings cause more dryer trouble than broken parts do. Follow this route first.
Still damp after all that?Book a visit and one of our certified and insured pros will diagnose it.
Book NowSend us the short form and we'll phone you back to pick an arrival window together. Tell us which appliance is acting up and its brand, so the technician can load the right parts into the van.
(587) 111-1111Rather talk it through? We answer 7am – 11pm, Monday through Sunday.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.